Belt Bonder Welding Procedure

	Cut belt to desired length. Clean belt surface to remove dirt and grease. Pre-heat welder at least 10 minutes.
	For adequate over- hang on each side, clamp profile in Belt Bonder fixture using belt locator bar supplied.
	Place the heated welder head between the belt ends and close bonder jaws lightly until the profile ends melt equally and form approximately a 1/16" bead.
	Open the bonder and quickly pull welder away. Avoid dragging melted material out of joint area.
	Close bonder quickly allowing pre-set spring pressure to hold jaws firmly together. Depending on belt diameter, wait 6- 10 minutes for heated area to cool.
	Take welded belt out of Belt Bonder and remove welding flash from belt with trim cutters or trim knife. Belt is welded and ready for service!

DISTRIBUTED BY: